This is the first public collective experiment to test a new system of automatic result processing.
Read details below to learn more about this experiment.
Held on:
September 17, 2019 at 04:02PM UTC
Duration:
30 mins
4
Instructions:
The experiment will start at a "Start Date" and will last a specific amount of minutes which indicated above. You can also see a countdown - time left before the experiment.
When the countdown is finished, the experiment begins.
During the experiment time, you can try to influence the water sample through a diagram. To do so click on "Start Session" (this button will be available only during the experiment) and you will the diagram. The diagram is considered to be an entanglement key to the real object which during the experiment is placed into experimental setup - Electrochemical Impedance Spectrometer (EIS).
When the experiment in progress you can see the plots that are created by EIS. These plots show the impedance of "Test" and "Control" samples.
Concentrate your attention on the diagram and apply your intention to make water in the container more conductive.
Perform concentration for as long as you wish and when finished click "Finish Session".
When the experiment is finished you will see the results on this page at the "Results" section.
If you have any feedback (e.g. on usability) you can leave your comment in a "Comment" section of this page or send us an email at [email protected]
1. It turned out that some people were concentrating on different or both channels. 2. In a result of the session channel 1 got very small Psi value = 0.4. But our experience shows that it is important to check how the device behaved in the next sessions. On the graph below you can see that in the next sessions Psi values were increasing and reached record values!
Next sessions
September 17, 2019 | 18:34 UTC, Anton Fedorenko says:
I mostly was focusing on ch1 (red), but sometimes was thinking about ch2 (black) Reply